The number one cause is a clogged filter. Leave the cover on the spa to retain as much heat as possible. (Facing control panel, usually behind right wooden section) Make sure it is not touching any components, wires, or insulation and replace the wooden panel to the best of your ability. If the spa has no power, or is not heating, place a droplight with a 60 or 75-watt bulb inside the access panel over pump one. My spa has no power or is not heating and it is a cold winter day, what do I do? It is the vibration of ozone being sucked through the Mazzi Injector. My OZONE is humming, is there something wrong? You should try locating/resetting this reset button before calling for an appointment.
HOT SPRING IQ 2020 MANUAL MANUAL
If a Hot Spring Spa: Some heaters have a reset button, refer to owner’s manual for location or other tips.
Use SYSTEM FLUSH at least once a year to help remove organic build up in the heater. Is SPA STAIN & SCALE used weekly? This prevents calcium buildup on the heater, which will lead to inefficient heat transfer. The controls are set in continuous heat mode (standard thermostat) and/or programmed for several hours of heating. If it begins heating you know it is the filter causing the problem. After leaving the spa off for 45 minutes turn the spa back on without the filters in the spa to see if it begins heating. In order to test whether or not the filter is the cause of a no-heat situation, turn the power off to the spa at the main breaker: Take out the filter out of the spa (make sure that nothing is floating in the spa that could get sucked into the filter area). The filter has been cleaned within the last four weeks by soaking it in BEAR STRIP FILTER CLEAN and that filter is not older than 18 months. The water is at a level which covers all of the jets as this affects the water flow through the heater.
0 kommentar(er)
